Support Forum

Hi guys... I cant understand how do it... I need help... I'm using the program FreeStyler ver. 3.5.1. and Magic 3D Easy View. I'm created fixtures in the FreeStyler program and Scanlibrary Editor... But I cant Understand how to connect two fixtures for 3D and for FreeStyler.

Ok. My steps.
I'm open the program Freestyler
Click on "Setup" and "Add/Remove fixtures
Added my eight fixtures "name Robosacn 575MHI-II
click on the 3D icon and opened empty scene. Why???
Where my scaner?

Ok. My steps for 3D Easy View
I'm created in the program "scanlibrary editor" my 3D scaner "Roboscan 575MHI-II"
next step I added him on the scene
but how used him??? If this fixture and fixture for Freestyler no connected?

Hi, FS and EV are two separate but compatible programmes.

You have to set up the fixtures on EV with the same DMX addressing as FS.

Have you setup FS to send to EV by setting up the 'virtual interface' ....??

Do this by going to FS - Setup - Freestyler Setup - Virtual Interface...??

Rgds

Mac