problem with easyview 3d after upgrade
Posted: 18 Sep 2012, 21:36
Hi
I upgraded my PC to 3.4.8 last week.
I only have 2 different types of fixtures in my current setup --- NJD Spectres & LEDJ Slimline 229s.
All seems fine until I open magic 3d. Spectres work fine, but I can only get the 229s to come on if I turn on the strobe. With the strobe channel at 0 the visual is off.
Is there any way I can reverse to my earlier version (magic 3d too as this updated as well)
I upgraded my PC to 3.4.8 last week.
I only have 2 different types of fixtures in my current setup --- NJD Spectres & LEDJ Slimline 229s.
All seems fine until I open magic 3d. Spectres work fine, but I can only get the 229s to come on if I turn on the strobe. With the strobe channel at 0 the visual is off.
Is there any way I can reverse to my earlier version (magic 3d too as this updated as well)