Afterglow Aurora 2 - No Interface Detected
Posted: July 14th, 2012, 9:27 pm
Hiya,
I'm hoping someone maybe able to help me. I've had an Aurora 2 for a while, haven't got around to using it. I have 2 Clay Paky Mini Scan HPE's I'm trying to connect up to it. When I load FreeStlyer (I'm on the latest version) it is coming up saying that No Compatable Interface Detected - No Interface Detected. Enter Demo Mode?
I know that the Aurora 2 is working as I can use it with DMXControl. Obviously FreeStyler is a much better product so if I could I would really like to use this. I had a look at some old posts from the old Forum saying that there was a Driver problem, was this remedied? I downloaded the USB Driver off the Next Generation Technologies Site. I tried to use the Enttec Open DMX option via FreeStyler, this just came back with Open Failed! Any advice would be very welcome.
Many thanks,
Gavin.
I'm hoping someone maybe able to help me. I've had an Aurora 2 for a while, haven't got around to using it. I have 2 Clay Paky Mini Scan HPE's I'm trying to connect up to it. When I load FreeStlyer (I'm on the latest version) it is coming up saying that No Compatable Interface Detected - No Interface Detected. Enter Demo Mode?
I know that the Aurora 2 is working as I can use it with DMXControl. Obviously FreeStyler is a much better product so if I could I would really like to use this. I had a look at some old posts from the old Forum saying that there was a Driver problem, was this remedied? I downloaded the USB Driver off the Next Generation Technologies Site. I tried to use the Enttec Open DMX option via FreeStyler, this just came back with Open Failed! Any advice would be very welcome.
Many thanks,
Gavin.