Support Forum

I have a LIVE show to do for a few bands on Saturday and I had a few questions before I buy this midi controller.

Will I be able to assisgn the faders to Pan/Tilt and assign them to play sequences?

I want to know if this is sutible for a live event.

Also, I was wondering if freestyler had a command line system like the ETC console I'm working off of.

Channel 52 + 55 @ FULL in some type of command?

Those are my questions, thank you .

Hej mattjake4

Yes you can use Midi faders to Start/stop Sequences ( Submaster intentensitie And Start/Stop control )

Yes you can also assinge the Pan/tilt to a Fader. BUT this only works with The Current Selected Fixture.


And YES! freestyler also have a Command Line System. You can find it on the Toolbar as "GO"

and on this this page you can see all the Command you can use.
http://www.freestylersupport.com/wiki/p ... un_command

and here you can find all the External commands you can use.
http://www.freestylersupport.com/wiki/e ... l_commands

and i use the BCF2000 and it works realy nice.

/spirit

Hi Spirit,

Apparently you have a big how-know about BCF2000

I just bought it 2 days ago and I would like to know what you recommand to use it, please ?

Till now I used external keyboards with sequences which I prepared before the show.

But I really need sometimes to interrupt the sequence and play with heads of lyres for example

Thanks a lot

Best regards,

Spirit wrote: And YES! freestyler also have a Command Line System. You can find it on the Toolbar
and on this this page you can see all the Command you can use.
http://www.freestylersupport.com/wiki/p ... un_command

and here you can find all the External commands you can use.
http://www.freestylersupport.com/wiki/e ... l_commands

Hi,

Thanks for posting the link to the list of commands.

I'm trying to use OpenRemote to control FreeStyler, which in turn is driving some DMx to SPI LEDs.

I can't seem to find out how to phrase a TCP command correctly.

I have a TCP accessible relay board which responds really well.


All I want to do is start and stop sequences.

If I get really adventurous, I might try to change the speed by sending a TCP command.


Any assistance would be welcomed.