Support Forum

Is there a way to use the dimmer channels in the sub htp.Mi explain better if I have the master 1 dimmer 1
to 50 and raising the sub 2 Dim1 I should bring to 100 to 100 2 and dim.
Now raising sub 1 sub 2 ok but raising my first dim is 1 then goes to zero is 100, how can I do
that goes from 50 to 100 in the scene 1 scene 2 without going from 0
Sorry for my English

Hello, Peolo

i do not realy understand you.
can you explaine your problem Step by step.

/spirit

I have a problem with the HTP.
For example: i have 2 scenes: 1 memorized in the submaster 1 and another one memorized in the submaster 2.
By the first submaster I control light 1, by the second submaster I control light 1 and light 2. If i raise up the first submaster (from 0 to 10) and i set
it to 5, light 1 works good, and everything is ok.Then, when i raise up the second submaster starting from 0 (the first sub is still set to 5) light 1 goes
down (it was set to 5) before to increase again.
In few words: when i raise up submaster 2 (with submaster 1 set to 5), instead of being added to submaster 1, submaster 2 shoots down submaster 1.

hello,

i did found a bug but can you also say which version you run.

the most stable version is 3.3.2 http://www.freestylerdmx.be/

hello

I can not in all versions 3.3.2 -3.4
example:

submaster 1 dimmer1=50 dimmer2= 100 dimmer3=0 dim .......

submaster 2 dimmer1=100 dimmer2=0 dimmer3=100 dim .......

i must do fade between submaster1 and submaster2 ,but io don't wont than dommer1 go down to 0 when i pump up submaster2 ,i'd like that dimmer1 have always the higher value (htp)
now all channels work for me in the LTP.
Usually work in HTP dimmer channels
Highest Takes Precedence (HTP) and Latest Takes Precedence (LTP

ahh yet now i understand you, and yes you'r right.

The Submasters works with LTP

But the slider next to a submaster works with HTP

/spirit

I'sorry, I try to explain...
This is my problem: I'd like that sliders work between themselves in htp.
In my last example submaster I mean intensity sliders; because I want a manual control of sliders, like
teather with conventional and unconventional lights.
Excuse my English

I'sorry, I try to explain...
This is my problem: I'd like that sliders work between themselves in htp.
In my last example submaster I mean intensity sliders; because I want a manual control of sliders, like
teather with conventional and unconventional lights.
Excuse my English