Page 1 of 1
Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 18 Mar 2011, 00:27
by inthemixproductions
please help me i have created a mojo spin master 2 but it keeps flashing and i can't figure how to make it stop flashing please help me
Re: Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 20 Mar 2011, 16:18
by LJ_krede.dk
I need the manual or at least a DMX chart/overview to help you
Re: Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 20 Mar 2011, 21:40
by Jan_K
Hej Krede
The DMX channel table is here.
I have not been looking into it or the problem.
(Am looking on a movinghead that don't performe as expexted)
http://www.freestylersupport.com/fsforu ... =79&t=3477
Re: Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 20 Mar 2011, 21:48
by LJ_krede.dk
Thanks Jan.
@ inthemixproductions
does not seem to be an issue with the FS fixture. I would change the feafult shutter value to 5 if i were you thou.. Are you sure you have et up the right addresses in FS AND the Fixture itself
Re: Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 21 Mar 2011, 11:48
by Jan_K
You can also try to use the fader in the right side of freestyler and then manualy with the hw. see where it changes.
/Jan
Re: Geni Mojo Spin Master 3 and 2 (PLEASE HELP)
Posted: 11 Apr 2011, 14:06
by inthemixproductions
Hi guys I figured out that it was a problem with my interface the interface I bought reliys on the computer to send the dmx signal it is not made int he interface so I am going to seel that interface to save up for a new interface