Support Forum

Hello, I'm a total noob and I've spent the better part of the last week getting familiar with Freestyler and my new Gus USB-VL344 DMX interface. I've been able to add fixtures, set scenes, run cues and am feeling comfortable enough with Freestyler, but nothing I do can get Magic 3D Easy View out of limited mode. The interface is listed in FS as supported, and I've tried the Enttec Open DMX and Virtual Interface settings in FS as well.

I've tried uninstalling and reinstalling FS and Easy View, on 2 different PC's, and have tried various interface settings in FS, but still I'm running Easy View in limited mode only every time it launches.

Am I missing something here? I've toggled everything I can think of and I still can't get into the full mode of Easy View.

There must be something I'm overlooking...

Thanks!

as far as i know you can't get Easy view in full mode.. At least FS can't get it out of it.. I almost sure the most FS user only use limited mode.. There is a very old post describing how to get Easy view in full mode but i can't remember which one or if it is still possible.

any ways.. I think full mode is when you use a Sunlite interface