stopping a Cue, Moving Head goes to Pan=0 / Tilt=0

[power-button]

Hello,
when I stop a running Cue by pressing the Cue-button, my Moving Heads run back in Pan=0 / Tilt=0 Position.
Is there any way, I can set that to Pan=127 / Tilt=127 ???

Thanks

-------------------

DEUTSCH :
wenn ich ein laufendes Cue stoppe, durch drücken der entsprechenden Cue Taste, fahren meine Moving Heads in Pan=0 / Tilt=0 Position.
Gibt es eine Möglichkeit dies in Pan=127 / Tilt=127 zu ändern ???

[djSupport]

Move your head/scanner to where you want them to be then while there selected click the edit menu and save as start-up values in the cue area click the arrow that bends round back on itself "restore values" when you stop the cue it will make the lights go back to the starting position you set! I believe thats the way

[LJ_krede.dk]

From: Raphael
to Kristian
date 25 July 2009 18:26

In some older version this was the case, but the problem was when using multiselect, FS had problems getting the initial values (if you disable the sequences in a different order)
That is why I let all the channels go to 0.