Page 1 of 1
BCF2000 in a Flightcase
Posted: 27 May 2010, 09:55
by Crxtreem
Have someone mounted his BCF2000 in a 19"flightcase?
I want place my BCF in a prodjuser Slant flightcase.
But there are no mountingbrackets for the bcf.
does someone have an idea or example?
Re: BCF2000 in a Flightcase
Posted: 31 May 2010, 12:33
by stuv
I imagine it would be rather easy to remove the 2 plastic bevels (2 x screws each + clips) and replace them with some home made rack ears made to fit. I have not done this as i have no need, however it could be accomplished quite easily and cheaply.
Re: BCF2000 in a Flightcase
Posted: 31 May 2010, 13:19
by dmxlighting
Perhaps you could purchase a foamed out case for your BCF. There are no factory made rack ears for it and the plasic sides of the BCF don't come off easily and will invalidate your warrenty in the process.
Re: BCF2000 in a Flightcase
Posted: 03 Jun 2010, 12:16
by stuv
The plastic sides aren't too hard to remove as long as you understand the clip mechanism, and I doubt it would void your warranty unless you broke them in the process...
Re: BCF2000 in a Flightcase
Posted: 22 Jul 2010, 12:02
by Crxtreem
Re: BCF2000 in a Flightcase
Posted: 22 Jul 2010, 13:59
by remco_k
Nice work.
Offtopic:
Wow!!!! A DLC 1810! (Ordered at Conrad some long time ago??)
I've had the same device when I was like 15 years old (about 20 years ago now). Loved it! But destroyed it doing some stupid things with electronics...
Then I made my own light controller using a home computer with an relais interface connected to it (with 8 relais), made some software for it and that replaced my dead DLC 1810.
