Support Forum

Hi, i wonder if it's possible, in any way, to control 4 fixtures of the same kind (LED-PAR 64 Spots) with just one Midi-Channel?!
For example i want to control the 3 colorchannels by a keyboard, so that i can "play" the colors for all 4 fixtures at the same time. For one fixture it works fine, but i have no idea how to do this with 4 fixtures.
All fixtures running on different DMX-Adresses cause i also want to control the 4 LED-Spots via DMX400.

Is there any way to do that?

Thanks, Blade

and you only want to use one midi channel? i dont how to do that
if you use three it's possible:

1) make a cue with a transparent sequence that turn on red for all four fixtures
2) make a cue with a transparent that turn on green for all four fixtures
3) make a cue with a transparent that turn on blue for all four fixtures

4) open the submaster window and insert each cue in different submasters, example: 1, 2 and three
5) start the three submasters
6) now you can controll all four fixtures at same time, and mixing the color

if you find a better solution, let me know

EDIT: you can also make serveal sequence with different colors in one cue, and the select the colors from keyboard shutcuts

Of course i want one Midi-Channel for one Color , maybe i've wrote it a little bit incomprehensibly , I'm not native in english, so I apologize for this .

I will try it this way.

Thank you, Blade

Ive tried it but it don't work, i've created the cues und load them into the 3 submasters.
When I start the submasters, all 4 fixtures are instant on, I can't change anything, either the color nor the intensity.

I have no idea what I'm doing wrong.


Blade

Blade_Vampire wrote:Hi, i wonder if it's possible, in any way, to control 4 fixtures of the same kind (LED-PAR 64 Spots) with just one Midi-Channel?!
For example i want to control the 3 colorchannels by a keyboard, so that i can "play" the colors for all 4 fixtures at the same time. For one fixture it works fine, but i have no idea how to do this with 4 fixtures.

Is there any way to do that?

Thanks, Blade

[Have editted OP]

Same basic request but this time in Magic 3d Visualiser. I can't figure out how to patch multiple lights on to a single channel address. Needing to run pairs of Par56's but the visualiser will only allow one light per patch?

Help please if possible!