Possible noob question.

[shane_saintsfc]

Hi Guys

I have so far managed to figure out the software without asking too many questions. I have 4 ADJ Mega Par profiles and using the fixture for the ADJ Flat Par Tri which works fine. I have created some sequences which work fine when playing them within the editor. When I add them to cues, the first one I play works ok but if I press play on a second one, the colours are not what was set in the sequence editor. It's like it keeps the colours there from the first cue I played ruining the 2nd one?

Any ideas?

[Spirit]

hi look at this link i think this is your problem.
http://www.freestylersupport.com/wiki/c ... d_tutorial

But this goes about the Submasters but how to program a Sequence stays the same.
if it sill doesnt work or you dont understand it just ask again.

/spirit

[shane_saintsfc]

Cheers! Sorted out the colour problem. That link helped.

Only thing left to concur now is when pressing a cue after a strobe effect, it strobe for the first second or so.

[Spirit]

uhmm can you axplain this a little nit more because i dont understand it.

/spirit

[shane_saintsfc]

Basically if I go from a strobe effect on cue to a fade. It will still strobe at the beginning of the new cue/scene