Page 1 of 1
Showtec lightfoot 4 no go ???
Posted: May 26th, 2011, 7:42 pm
by blue slate mike
I have a showtec lightfoot4 DMX and It doesn't willn't to work with a starville led cans. Will this unit only work showtec cans?? The lights work with my controller and a enttec Open DMX USB Interface ?
mike d
Re: Showtec lightfoot 4 no go ???
Posted: March 6th, 2012, 2:32 pm
by ug999
hi,
late answer, but perhaps it helps somebody.
it'll work, but with a lot of restrictions:
as the controller is made to control a max. of 4 par cans (single color), all programs and chases will not work!
You can only use the scene mode.
Set the cans to channel 1 (so the controlled channels will be 1-4) (dip1 on, rest off).
ch. 2-4 will control the colors (0-255)
ch. 1 must be set to 0 in order to have rgb control for ch. 2-4
Now you can programm any colored scene and blackout as you like.
Re: Showtec lightfoot 4 no go ???
Posted: November 26th, 2012, 9:55 am
by bloodandtears
Sorry for the necro post, but I have the same setup as the OP but I cannot make this work at all.. please help..