Output testing on FTDI232?
Posted: April 23rd, 2019, 7:09 am
Dear All.
I may be missing soemthing but I can't get an FTDI232 to output to a basic RGB Par,
Windows has detected and installed USB-Serial on COM3..
In FS setup I select Entec Open DMX, and it shows FTDI232.
We create a basic 3 Ch fixture, correctly addressed.
On the fixture we set the output levels (not sure this step is right ) using the little set of sliders shown to the right of the screen..
Is there something else we need to do.
(The interface works fine on QLC, so it's not a hardware issue)
Cheers
Rob
I may be missing soemthing but I can't get an FTDI232 to output to a basic RGB Par,
Windows has detected and installed USB-Serial on COM3..
In FS setup I select Entec Open DMX, and it shows FTDI232.
We create a basic 3 Ch fixture, correctly addressed.
On the fixture we set the output levels (not sure this step is right ) using the little set of sliders shown to the right of the screen..
Is there something else we need to do.
(The interface works fine on QLC, so it's not a hardware issue)
Cheers
Rob