Support Forum

Hi could anyone point me in the right directon to make this fixture file, i have tried my self and failed miserably 3 channel mode id what i am after.

thank you

Hej

I think the easy way for you to do this is just make a fixture with the total channels set to 3 for a start.

Nothing else.

Then you will have 3 sliders in the right side of FreeStyler which you can play with and actually see that you have control over the fixture.

When you can see that you have control then you can start modifying the fixture.
My suggestion is:
Channe1 on Color wheel 1

Channel 2 on Gobo wheel 1
Channel 3 on Gobo rot 1

/Jan

hey

Thanks for the pointers Jan i now have some control over this fixture, i can not get the color's to match up would you mind having a look at the fixture for me and telling me where im going wrong.

Hej Again

First of all are you sure that you are running the fixture in 3 channel mode and not 8 Channel.
(There are difference in the colors depending on the mode)

You don't white what is wrong with the color but if it is running in 3 ch mode then.
You have two black icons. They are both correct so it is more cosmetic.
If you change the 7 to 255 and the color icon to white. (There is a white icon with a black frame which is easy to see)

All colors until 157, the yellow are okay.
In the data sheet the DMX value are to be 135 to 149 for the yellow one.

And this is then the problem with the rest of the table. They are offset.

/Jan

You can eventually have a look on this one.
/Jan

Thank you jan i made some adjustments like you said, i some control but not all i will take a look at the fixture file that you have provided over the weekend

When you have something that you think is working good then remember to upload it here so other can benefit from it.

Thank you Jan i sure will upload the fixture file when it is complete