LED Bar Built In Program Accessing... [SOLVED]
Posted: November 6th, 2014, 8:47 am
Good evening all,
I have a pair of Ehrgeiz FS-60 RGB Bars that I am connecting to via DMX/Freestyler. I have a fixture file currenty to have it run in mode 2 (RGB + Dimmer & Strobe), but I am going to get around to the 60 channel fixture file....
Now, these units have 18 built in Programs which are accessible from the menu at the rear of the fixture. How do I trigger these from within Freestyler?
The manual only supplies the DMX modes with channels etc, so nothing about Macros
Apologies if this post in in the wrong section...
Thanks Again.
I have a pair of Ehrgeiz FS-60 RGB Bars that I am connecting to via DMX/Freestyler. I have a fixture file currenty to have it run in mode 2 (RGB + Dimmer & Strobe), but I am going to get around to the 60 channel fixture file....
Now, these units have 18 built in Programs which are accessible from the menu at the rear of the fixture. How do I trigger these from within Freestyler?
The manual only supplies the DMX modes with channels etc, so nothing about Macros
Apologies if this post in in the wrong section...
Thanks Again.