fixtures:adding_and_removing_fixtures
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
fixtures:adding_and_removing_fixtures [2019/01/28 20:02] – [Options] Jan_K | fixtures:adding_and_removing_fixtures [2019/01/29 06:59] (current) – [Options] Jan_K | ||
---|---|---|---|
Line 143: | Line 143: | ||
{{: | {{: | ||
- | To remove fixtures you would open the " | + | To remove fixtures you would open the " |
- | + | \\ | |
- | {{: | + | Before you removing a fixture it is a good idea to consider what will be affected by this removal. If the fixture never has been added / programmed into a sequence then just remove it.\\ |
- | + | But in the case where it has been programmed into a sequence then it will be a good idea to clean up the sequences.\\ This is to avoid a new fixture | |
- | You will be given a prompt when you click the blue arrow that asks "Do you want to clean-up your sequences?". What the Sequence Cleaner does is enable you to select any sequences you have and removes the channels associated with the fixture | + | So the advise |
- | + | \\ | |
- | + | \\ | |
- | {{: | + | {{: |
- | + | \\ | |
- | As you can see the fixture has been removed from the list on the right. | + | Click on the remove arrow and as you can see the fixture has been removed from the list on the right.\\ |
You can now close this dialogue.\\ | You can now close this dialogue.\\ | ||
Line 189: | Line 189: | ||
| | ||
\\ | \\ | ||
+ | \\ | ||
+ | ------ | ||
\\ | \\ | ||
=== Cleanup sequences. === | === Cleanup sequences. === | ||
Line 197: | Line 199: | ||
\\ | \\ | ||
\\ | \\ | ||
+ | ------ | ||
\\ | \\ | ||
=== Print fixture list. === | === Print fixture list. === |
fixtures/adding_and_removing_fixtures.1548705745.txt.gz · Last modified: 2019/01/28 20:02 by Jan_K