fixture_creator:movement_configuration
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
fixture_creator_movement_configuration [2011/06/17 19:50] – created Jan_K | fixture_creator:movement_configuration [2013/03/11 03:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Fixture Creator - Movement configuration ====== | ====== Fixture Creator - Movement configuration ====== | ||
+ | \\ | ||
+ | The minimum definition of the Movement is only the Pan 8bit channel.\\ | ||
+ | This can be used when a fixture only have one direction to move for example the mirror.\\ | ||
+ | The American DJ tripleflex is an example on this. See: [[fixture_creator: | ||
+ | If only Pan is configurated then Tilt is still present in the movement panel but it don’t have any control effect.\\ | ||
+ | \\ | ||
+ | To control the movement 8 or 16 bits are used depending on the fixture.\\ | ||
+ | Many scanners only need 8 bit because of the relative limited movement.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | Moving heads can normally be adjusted more than 360 deg. and to get a smooth movement control this offend require 16bit for the Pan channel and 16 bit for the Tilt Channel.\\ | ||
+ | It is only possible to transmit 8bits in one channel so to transmit 16 bits two channel are required but this are stated in the fixture.\\ | ||
+ | \\ | ||
+ | As it can be seen bellow the course part of the control goes into the 8 bit channel and the fine part of the control goes into the 16bit past.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | NOTE:\\ | ||
+ | It is important to set the default value for the movement control. If nothing is mentioned in the manual for the fixture then the middle value is used, 128.\\ | ||
+ | The default value is the position / direction the fixture points into on start up. If the value 0 is used the fixture will point into one side.\\ | ||
+ | See: [[fixture_creator: | ||
+ | \\ | ||
+ | An extra parameter is Range. This is the max movement in deg.\\ | ||
+ | This parameter is not a requirement.\\ | ||
+ | \\ | ||
+ | Here the fixture has a Pan Range of 540 deg and a Tilt Range of 267 deg.\\ | ||
- | No text yet | + | {{: |
+ | \\ | ||
+ | This parameter is used by the ”Flip” function in the Moving control panel.\\ | ||
+ | For the " | ||
+ | This actually means that it is only actual for moving heads.\\ | ||
+ | If this parameter isn't set then default values will be used.\\ | ||
+ | Default is Pan = 540 and Tilt = 270.\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | ---- |
fixture_creator/movement_configuration.1308340255.txt.gz · Last modified: 2013/03/11 02:59 (external edit)