fixture_creator:framing_configuration
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
fixture_creator_framing_configuration [2011/06/30 19:48] – created Jan_K | fixture_creator:framing_configuration [2013/03/11 03:45] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 6: | Line 6: | ||
Framing is enabled by check on the Enable Framing box.\\ | Framing is enabled by check on the Enable Framing box.\\ | ||
\\ | \\ | ||
+ | {{: | ||
\\ | \\ | ||
+ | Configuration of the Framing blade control is on the “Framing config” tab.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | The control is defined as a position in each corner of the blade. This is the only type of definition that are available at the moment.\\ | ||
+ | Fixture as Martin MAC III performance has a blade definition consisting of Position and Angle for each blade. This is not configurable at the moment.\\ | ||
+ | \\ | ||
+ | Additional to the 4x2 position channels a " | ||
+ | \\ | ||
+ | ---- | ||
\\ | \\ | ||
- |
fixture_creator/framing_configuration.1309463333.txt.gz · Last modified: 2013/03/11 02:59 (external edit)