Differences

This shows you the differences between two versions of the page.

--- fixture_control:sliders [2013/03/11 03:45] – external edit 127.0.0.1
+++ fixture_control:sliders [2015/09/15 06:33] (current) – Jan_K
@@ Line 17: / Line 17: @@
 Now you can move the slider for each attribute of the fixture simply by moving the mouse cursor onto a slider and then by holding down the left mouse button move the left and right until you get the desired dmx values.
+\\
+**NOTE:** Why should i do it like this if you also have the Panels with all the attributes, Thats because NOT allways you have all the functions that a fixture can do displayed on the panels, so sometimes a Fixture can do more then you think.
+\\
+**NOTE:** Also look out for the Shutter/Lamp channel most of the time if you have a movinghead you can set the Lamp on and off with these channels. but it can take up to 15min before you can set the lamp on again, also it can be bad if your lamp goes off and on all the time in a small amount of time, so be carefull if you drag these Slider.
+\\
+\\
 **Fine control.**\\
 It can be a bit tricky to fine control the faders in the fixture control panels with a mouse. In the “Slider” panel the last touched slider can be additional controlled with the +, - on the num pad.\\
@@ Line 23: / Line 28: @@
 \\
 \\
-**NOTE:** Why should i do it like this if you also have the Panels with all the attributes, Thats because NOT allways you have all the functions that a fixture can do displayed on the panels, so sometimes a Fixture can do more then you think.
-**NOTE:** Also look out for the Shutter/Lamp channel most of the time if you have a movinghead you can set the Lamp on and off with these channels. but it can take up to 15min before you can set the lamp on again, also it can be bad if your lamp goes off and on all the time in a small amount of time, so be carefull if you drag these Slider.
-\\
 **Drop down menu.**\\
 By making a “right mouse click” a drop down menu appears where it is possible to make some channel manipulation direct on the fader.\\
 See [[fixture_control:slider_menu|]]\\
 \\
+If a channel has been manipulated then there will be "***" in front of the name on the slider and the color of the slider change a bit. \\
+This is to indicated that on this channel something is changed so it is not the slider value direct which is send to the fixture.\\
+\\
+{{:fixture_control:manipulated_slider.jpg|}}
 \\
 \\
-As an alternative to this method and as show below you can open up all the fixtures attribute windows and as you adjust the colour wheel, it will show the value on the slider.
+\\
+As an alternative to this slider method mentioned above and as show below you can open up all the fixtures attribute windows and as you adjust the colour wheel, it will show the value on the slider.