Lamps continue to light after finishing a cue even when the program is closed
Posted: July 18th, 2018, 10:55 pm
Hello
hardware
Enttec dmx Pro MK2
software
Freestyler (latest version)
problem
I imagine the problem is new to me !!!
But I can also be wrong because I had only run S2Ll function.
Since I had only ever S2L function active I did not really noticed. But tell me that I did not have the problem as it is now.
I imagine the problem is new to me !!!
But I can also be wrong because I had only run S2Ll function.
Imo I work very intensely with freestyler and create cues modify / create my fixtures even so far everything i.o (I hope)
Now I let a cue run when I run this out the devices as in the freeze function just continue. Even if I close Freestyler.
I restart Freestyler everything is off (as it should)
I disconnect the lights from the network and I turn them back on are the play mode again (Note Freestyler is not on)
If I pull the USB cable out after closing Freestyler, it takes a while and then they go out.
All devices (mostly ADJ) are in the menu with missing DMX signal blacked out.
Have the feeling that the Enntec stores the last DMX sequences and sends on missing DMX signal on. Is there a switch?
Do I have something to clean up at the fixtures ...?
Ordinary goes in and out of gobos and so on, everything goes ...
Hope you have a tip
Greetings from Berlin
Ralf
hardware
Enttec dmx Pro MK2
software
Freestyler (latest version)
problem
I imagine the problem is new to me !!!
But I can also be wrong because I had only run S2Ll function.
Since I had only ever S2L function active I did not really noticed. But tell me that I did not have the problem as it is now.
I imagine the problem is new to me !!!
But I can also be wrong because I had only run S2Ll function.
Imo I work very intensely with freestyler and create cues modify / create my fixtures even so far everything i.o (I hope)
Now I let a cue run when I run this out the devices as in the freeze function just continue. Even if I close Freestyler.
I restart Freestyler everything is off (as it should)
I disconnect the lights from the network and I turn them back on are the play mode again (Note Freestyler is not on)
If I pull the USB cable out after closing Freestyler, it takes a while and then they go out.
All devices (mostly ADJ) are in the menu with missing DMX signal blacked out.
Have the feeling that the Enntec stores the last DMX sequences and sends on missing DMX signal on. Is there a switch?
Do I have something to clean up at the fixtures ...?
Ordinary goes in and out of gobos and so on, everything goes ...
Hope you have a tip
Greetings from Berlin
Ralf