Switching from one cue to another

[j_dunavin]

I have pre programed several sequences, and when I run them from my cue list I notice that it gets stuck on the last cue set up. Like the gobo doesn't reset. I have to manually set the pan and tilt to zero and make all white with an open gobo then restart the cue.
Is there a way to start and stop one cue and start the next from the beginning?
I did select "start from the beginning" in the cue list options.

Also....
How do I start n stop a submaster while a cue is playing?

Should I not run my sequences from the cue list?

[kittmaster]

Are you using the cuelist buttons for triggering? If so, the gear above the cuelist buttons select "Disable previous cuelist first" and that will do what you are expecting. This was a feature I asked for that the dev added for this type of operation.

See if that works for what you're asking for.

[j_dunavin]

Thanks I'll give it a try tonight

[j_dunavin]

Already had it checked.
I did find the problem though.
As it turns out some of my sequences have an open gobo, but I didn't specifically tell it to be open, I just left it alone. So the sequence didn't actually know to go to the open gobo if it where on another.
I went back into the sequence editor and told each step to have an open gobo or whatever I needed.
Problem solved! I can go from one cue to the next with. O problems!
Thanks for the help.

[kittmaster]

that makes sense too, you have to ensure all your off/snap/fades are set correctly for the sequence and the exit and entry points for another scene overtaking it.