Freestyler & Magic 3D - problem with KAM PAR BAR
Posted: January 7th, 2018, 11:02 pm
Hello,
Firstly I'd just like to say what fantastic pieces of software both Freestyler & Magic 3D are. I've still a lot to learn but I think I've grasped the fundamentals. I'm trying to preview a very basic stage light, a Kam LED Parbar, in 3d Easy View
I've sucessfully got the software controlling the light on stage during a couple of gigs and it was certainly an improvement on the presets! However, to program I had to connect to the physical light, not ideal because the drummer usually stores the lights.
I've managed to run Freestyler with Magic 3D which is receiving the DMX info. However the fixture, when loaded, appears as a flat rectangle and does not light up in any way. I've dropped other fixtures in and they are definitely receiving instructions, albeit the wrong ones.
The Kam LED Parbar is very simple: just four RBG lights. Both the Freestyler & Magic 3D fixture profiles seem to be set up correctly. One is labelled MkII and the other MKIII but the mapping (if that's the correct term) is exactly the same.
Any suggestions on what the problem could be would be gratefully received! Her'es a screengrab in case it's useful: https://drive.google.com/open?id=1wZPs3 ... GJ-2PX9YyI
Thanks,
Eric
Firstly I'd just like to say what fantastic pieces of software both Freestyler & Magic 3D are. I've still a lot to learn but I think I've grasped the fundamentals. I'm trying to preview a very basic stage light, a Kam LED Parbar, in 3d Easy View
I've sucessfully got the software controlling the light on stage during a couple of gigs and it was certainly an improvement on the presets! However, to program I had to connect to the physical light, not ideal because the drummer usually stores the lights.
I've managed to run Freestyler with Magic 3D which is receiving the DMX info. However the fixture, when loaded, appears as a flat rectangle and does not light up in any way. I've dropped other fixtures in and they are definitely receiving instructions, albeit the wrong ones.
The Kam LED Parbar is very simple: just four RBG lights. Both the Freestyler & Magic 3D fixture profiles seem to be set up correctly. One is labelled MkII and the other MKIII but the mapping (if that's the correct term) is exactly the same.
Any suggestions on what the problem could be would be gratefully received! Her'es a screengrab in case it's useful: https://drive.google.com/open?id=1wZPs3 ... GJ-2PX9YyI
Thanks,
Eric