Page 1 of 1

Master intesity bug, Also affects previous versions - FIXED

Posted: August 21st, 2007, 12:07 pm
by Mattotone
Hi.

There seems to be an error with the master intensity.

Setting the intensity of a fixture using the lamp dialog's, seems to
be ignorged by the master intensity.
For example if i set the intercity to 100%, then change the master
intercity to 50%, the fixture goes back to zero. set master intercity
to full, fixture still at 0%.

But if the master intensity is set to 50% and i the set the fixture to
100%, it reacts correctly and the fixture is a at 50%.

If you manually set the intensity of a fixture using the side bar
sliders, it works correctly.
However now adjusting the fixture intensity using the lamp dialog
still is disregarded by the master intensity as it reacts to the value
set by the side bar.

Matt

Re: Master intesity bug, Also affects previous versions

Posted: August 31st, 2007, 1:04 am
by cantyco
this might of jsut been me but i had probblems with this, and whenever i tryed to change the master intesity i used to have problems, and also got subscript errors, but i finaly discovered it was because one of my fixtures wasent assigned to a dmx channel. once i removed that fixture i didnt have any more problems. but this is a slighty different problem though.

Re: Master intesity bug, Also affects previous versions

Posted: August 31st, 2007, 10:35 am
by Mattotone
This has been fixed after the initial release of2.96G, If you have downloaded 2.96G before august the 24th please re download as the bug has now been rectified.