Page 1 of 1

Which kind of grease use to refurbish our DMX fixtures?

Posted: October 30th, 2017, 11:02 am
by Barabba
Hi all here! Thank you for kindly report your experience.

Does anyone here fixed/refurbished a DMX light?
I'm going to replace the LED chips on 6 scanners after 5 years 24h working, and I would like to add come grease to the mechanical parts too, may you kindly suggest me which kind of grease should I use? There are different types.. as I read I guess Silicone spray is better than CRC 5-56 or WD40 which by the time/hot can become "gum"..
I would like to use a spry to be able to reach difficult parts without unmounting all. Thank you for you kind help

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: October 30th, 2017, 11:08 am
by Barabba
Alternatively I can use oil for car engine, synthetic.. what you think?

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: January 1st, 2018, 11:52 pm
by MAAC
Molycote is what is being used in video recorders and tape deck gears

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: October 21st, 2021, 9:18 pm
by danmcr
I have a couple of moving heads that squeak when moving. I'm assuming this is due to a lack of lubrication. Any suggestions?

Thanks

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: October 21st, 2021, 11:56 pm
by SiGNe
For gears you need a more thicker lubricant, not a liquid one.
Like MAAC said, Molycote is a good one.

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: October 23rd, 2021, 7:14 am
by xever
Look for a specific grease for what you intend to lubricate, plastic gears, or metal bearings.

Stay away from CV grease as these are intended for heavy loads and high-pressure joints and rollers.

I typically use white lithium grease.

Re: Which kind of grease use to refurbish our DMX fixtures?

Posted: October 25th, 2021, 6:17 pm
by danmcr
Thanks for the suggestions.