Hey folks,
So I was running a setup on Friday 8th March which had a pair of Martin Mini Mac moving heads running and also an LED light. The problem I had was when I brought the LED in one of my moving heads kept getting effected by it and made the motor run slower than it should have been, so I wanted to ask why is this??
I have few ideas what was causing the problem but just wanted to ask, as it might have happened to you and you know how to sort it quickly?
Regards,
Nathan
Question about a minor problem
-
- Moderator
- Posts: 948
- Joined: September 18th, 2012, 9:32 pm
- FreeStyler Version: None
- I Use FreeStyler for: To help others here on the Forum!
- Kings
- Commited FS Forum helper
- Posts: 194
- Joined: October 12th, 2009, 5:51 am
- Twitter: twitter.com/
Re: Question about a minor problem
Check the DMX output when you 'bring in the LED' fixture. If you see a corresponding DMX value change on one of the mini mac channels then it will identify if it is a programming error.
-
- Moderator
- Posts: 948
- Joined: September 18th, 2012, 9:32 pm
- FreeStyler Version: None
- I Use FreeStyler for: To help others here on the Forum!
Re: Question about a minor problem
Thanks Kings,
I'll be sure to have a play about with this again when I get a few minutes spare to myself.
Regards,
Nathan
I'll be sure to have a play about with this again when I get a few minutes spare to myself.
Regards,
Nathan