These adverts are supporting the forum's costs and the products/services are not endorsed by the forum owners.
First have you tried?
Log in to Search the Forum for help!
Learn more about using FreeStyler at the FreeStyler WIKI HERE
Learn more about DMX in General at The DMX Wiki HERE

if all else fails and you need a fixture consider the fixture building service HERE

Problem with my DIY Artnet [Solved] Topic is solved

Discuss everything regarding DMX interfaces in this forum.
Post Reply
foxfox
Knows how to turn Lights ON
Posts: 3
Joined: May 26th, 2015, 4:00 am
FreeStyler Version: 3.5.9
I Use FreeStyler for: Just for the Fun of it.

Problem with my DIY Artnet [Solved]

Post by foxfox »

Hey there!
First of all, sorry if this is a repost. I can’t connect my ARTNET to my FreeStyler 3.5.9.

Unfortunately, everything in my country is very expensive so I must build my own tools
I got my interface from http://www.deskontrol.net/blog/nodo-art ... n-arduino/
I used an Arduino UNO, a SHIELD ETHERNET W5100 and a MAX485.
My computer runs with Windows XP 32bits. I configured the port
IP 2.0.0.1
Sunet-mask 255.0.0.0
Gateway 2.0.0.1
just like the tutorial explained.

Image


I downloaded DMX-Workshop to check if there was a problem with the connection between the FreeStyler and the interface.

Image


By using the Transmit Preset tool I can send a signal to my both Par Led RGB without any trouble.

Image


Am I using the correct configuration for the FreeStyler?

Image

If someone could give me a hand, I would really appreciate it!
Sorry for my lack of knowledge.
Thanks in advance!
Regards,


foxfox
Knows how to turn Lights ON
Posts: 3
Joined: May 26th, 2015, 4:00 am
FreeStyler Version: 3.5.9
I Use FreeStyler for: Just for the Fun of it.

Re: Problem with my DIY Artnet [Solved]

Post by foxfox »

I configured wrong FreeStyler ! :o :o :o :o :o :o

Image


Thanks you !!
Phil_bob
Knows how to turn Lights ON
Posts: 1
Joined: April 13th, 2016, 6:23 pm
FreeStyler Version: 3.6.3
I Use FreeStyler for: Stage Show

Re: Problem with my DIY Artnet [Solved]

Post by Phil_bob »

Hi foxfox, i'm doing the same project and it's not working at all.
I have tested my DMX output and it works fine.

An Arduino UNO, an ethernet shield W5100 and a MAX485 like you.

Same adress om FreeStyler V. 3.6.31

Can you help me?

Regards!
Post Reply

Return to “DMX Interfaces”